Dell PowerEdge SC1435 Hardware Owner's Manual - Page 51
Pull the socket-release lever 90 degrees upward until the processor is released from the socket. See
View all Dell PowerEdge SC1435 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Figure 3-9. Installing and Removing the Heat Sink 1 2 3 1 heat sink 2 heat-sink retention screw (2) 3 thermal grease protective cover 6 Wait 30 seconds for the heat sink to loosen from the processor. 7 If the heat sink has not separated from the processor, carefully rotate the heat sink in a clockwise, then counterclockwise, direction until it releases from the processor. Do not pry the heat sink from the processor. 8 Lift the heat sink off of the processor and set the heat sink on the work surface so it rests on the ends of the retention screws. 9 Use a clean lint-free cloth to remove any thermal grease from the surface of the processor shield. 10 Pull the socket-release lever 90 degrees upward until the processor is released from the socket. See Figure 3-10. Installing System Components 51