Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 120

• 16 - 16GFC • 32 - 32GFC • auto - Set the port speed to the speed of the installed media. Defaults Command Mode Usage Information Auto INTERFACE The speed command is supported only on the Management and Fibre Channel interfaces. This command is not supported on Ethernet interfaces. • To configure oversubscription for bursty storage traffic on a FC interface, use the speed command. Oversubscription allows a port to operate faster, but may result in traffic loss. For example, QSFP28 port groups in 4x8GFC mode support 16GFC oversubscription on member interfaces. QSFP28 breakout interfaces in 4x16GFC mode support 32GFC oversubscription. • The no version of this command resets the port speed to the default value auto. Example OS10(conf-if-fc-1/1/2)# speed 16 Supported Releases 10.3.1E or later speed (Management) Configures the transmission speed of the Management interface. Syntax Parameters speed {10 | 100 | 1000 | auto} Set the management port speed to: • 10 - 10M • 100 - 100M • 1000 - 1000M • auto - Set the port to auto-negotiate speed with a connected device. Defaults Command Mode Usage Information Auto INTERFACE The speed command is supported only on the Management and Fibre Channel interfaces. This command is not supported on Ethernet interfaces. • When you manually configure the management port speed, match the speed of the remote device. Dell EMC highly recommends using auto-negotiation for the management port. • The no version of this command resets the port speed to the default value auto. Example OS10(conf-if-ma-1/1/1)# speed auto Supported Releases 10.3.0E or later 120 Interfaces