Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 631
seq deny (MAC), seq deny icmp
![]() |
View all Dell PowerSwitch S4112F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 631 highlights
Example OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# seq 5 deny ipv6 any any capture session 1 count Supported Releases 10.2.0E or later seq deny (MAC) Assigns a sequence number to a deny filter in a MAC access list while creating the filter. Syntax Parameters seq sequence-number deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos | vlan] • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • nn:nn:nn:nn:nn:nn - Enter the source MAC address. • 00:00:00:00:00:00 - (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies. • any - (Optional) Set all routes which are subject to the filter: - protocol-number - Protocol number identified in the MAC header, from 600 to ffff. - capture - (Optional) Capture packets the filter processes. - cos - (Optional) CoS value, from 0 to 7. - vlan - (Optional) VLAN number, from 1 to 4093. Default Command Mode Usage Information Example Not configured CONFIG-MAC-ACL The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# mac access-list macacl OS10(conf-mac-acl)# seq 10 deny 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7 OS10(conf-mac-acl)# seq 20 deny 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2 Supported Releases 10.2.0E or later seq deny icmp Assigns a filter to deny Internet Control Message Protocol (ICMP) messages while creating the filter. Syntax seq sequence-number deny icmp [A.B.C.D | A.B.C.D/x | any | host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | dscp value| fragment] Parameters • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - dscp value - (Optional) Deny a packet based on the DSCP values, from 0 to 63. Access Control Lists 631
![](/manual_guide/products/dell-powerswitch-s3048on-os10-enterprise-edition-user-guide-release-10410-b76d862/631.png)