Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 479
track interface, virtual-address, Default, Command Mode, Usage Information, Example, Example Priority
View all Dell PowerSwitch S4112F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 479 highlights
Default Command Mode Usage Information Example 10 INTERFACE-VRRP If the interface is disabled, the cost value subtracts from the priority value and forces a new Master election. This election process is applicable when the priority value is lower than the priority value in the Backup virtual router. The no version of this command resets the value to the default. OS10(conf-eth1/1/5-vrid-254)# track 400 Example (Priority Cost) OS10(conf-eth1/1/5-vrid-254)# track 400 priority-cost 20 Supported Releases 10.2.0E or later track interface Monitors an interface and lowers the priority value of the VRRP group on that interface, if disabled. Syntax Parameters interface {ethernet node/slot/port[:subport]} [line-protocol] • ethernet node/slot/port[:subport] - (Optional) Enter the keyword and the interface information to track. • line-protocol - (Optional) Tracks the interface line-protocol operational status. Default Command Mode Usage Information Example Disabled EXEC Assign an object tracking unique ID number before tracking the interface. Use the line-protocol parameter to track for interface operational status information. The no version of this command resets the value to the default. OS10(config)# track 10 OS10(conf-track-10)# interface ethernet 1/1/5 Supported Releases 10.2.0E or later virtual-address Configures up to 10 virtual router IP addresses in the VRRP group. Set at least one virtual IP address for the VRRP group to start sending VRRP packets. Syntax virtual-address ip-address1 [ip-address2...ip-address10] Parameters • ip-address1 - Enter the IP address of a virtual router in A.B.C.D format. The IP address must be on the same subnet as the interface's primary IP address. • ip-address2...ip-address10 - (Optional) Enter up to nine additional IP addresses of virtual routers, separated by a space. The IP addresses must be on the same subnet as the interface's primary IP address. Default Command Mode Usage Information Enabled INTERFACE-VRRP The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address. When you delete the virtual address, the VRRP group stops sending VRRP packets. A system message appears after you enter or delete the virtual-address command. To guarantee that a VRRP group becomes Master, configure Layer 3 479