Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 407

5 Assign an IP address to the interface in INTERFACE mode. ip address ip-address/mask 6 Enable OSPFv2 on an interface in INTERFACE mode. ip ospf process-id area area-id • process-id-Enter the OSPFv2 process ID for a specific OSPF process from 1 to 65535. • area-id-Enter the OSPFv2 area ID as an IP address (A.B.C.D) or number from 1 to 65535. Enable OSPFv2 configuration OS10(config)# router ospf 100 OS10(conf-router-ospf-100)# exit OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# no shutdown OS10(conf-if-eth1/1/1)# no switchport OS10(conf-if-eth1/1/1)# ip address 11.1.1.1/24 OS10(conf-if-eth1/1/1)# ip ospf 100 area 0.0.0.0 View OSPFv2 configuration OS10# show running-configuration ospf ! interface ethernet1/1/1 ip ospf 100 area 0.0.0.0 ! router ospf 100 ... Assign router identifier For managing and troubleshooting purposes, you can assign a router ID for the OSPFv2 process. Use the router's IP address as the router ID. • Assign the router ID for the OSPFv2 process in ROUTER-OSPF mode router-id ip-address Assign router ID OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# router-id 10.10.1.5 View OSPFv2 status OS10# show ip ospf 10 Routing Process ospf 10 with ID 10.10.1.5 Supports only single TOS (TOS0) routes It is an Autonomous System Boundary Router It is Flooding according to RFC 2328 Convergence Level 0 Min LSA origination 0 msec, Min LSA arrival 1000 msec Min LSA hold time 5000 msec, Max LSA wait time 5000 msec Number of area in this router is 1, normal 1 stub 0 nssa 0 Area (0.0.0.0) Number of interface in this area is 3 SPF algorithm executed 38 times Area ranges are Stub areas Type 5 LSAs are not flooded into stub areas. The ABR advertises a default route into the stub area to which it is attached. Stub area routers use the default route to reach external destinations. Layer 3 407