Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 623
permit (IPv6), permit (MAC
![]() |
View all Dell PowerSwitch S4112F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 623 highlights
Example OS10(config)# ip access-list testflow OS10(conf-ipv4-acl)# permit udp any any capture session 1 Supported Releases 10.2.0E or later permit (IPv6) Configures a filter to allow packets with a specific IPv6 address. Syntax Parameters permit [protocol-number | icmp | ipv6 | tcp | udp] [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | dscp value | fragment] • protocol-number - (Optional) Enter the protocol number identified in the IPv6 header, from 0 to 255. • icmp - (Optional) Enter the ICMP address to permit. • ipv6 - (Optional) Enter the IPv6 address to permit. • tcp - (Optional) Enter the TCP address to permit. • udp - (Optional) Enter the UDP address to permit. • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - dscp value - (Optional) Permit a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# permit udp any any capture session 1 Supported Releases 10.2.0E or later permit (MAC) Configures a filter to allow packets with a specific MAC address. Syntax permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos | vlan] Parameters • nn:nn:nn:nn:nn:nn - Enter the MAC address. • 00:00:00:00:00:00 - (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies. • any - (Optional) Set which routes are subject to the filter: - protocol-number - Enter the MAC protocol number identified in the MAC header, from 600 to ffff. - capture - (Optional) Enter the capture packets the filter processes. Access Control Lists 623
![](/manual_guide/products/dell-powerswitch-s3048on-os10-enterprise-edition-user-guide-release-10410-b76d862/623.png)