Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 739

vlt-domain Creates a VLT domain. Syntax vlt-domain domain-id Parameter domain-id - Enter a VLT domain ID on each peer, from 1 to 255. Default None Command Mode CONFIGURATION Usage Information Configure the same VLT domain ID on each peer. If a VLT domain ID mismatch occurs on VLT peers, the VLTi link between peers does not activate. The no version of this command disables VLT. Example OS10(config)# vlt-domain 1 Supported Releases 10.2.0E or later vlt-port-channel Configures the ID used to map interfaces on VLT peers into a single VLT port-channel. Syntax Parameters Default Command Mode Usage Information Example (peer 1) vlt-port-channel vlt-lag-id vlt-lag-id - Enter a VLT port-channel ID, from 1 to 1024. Not configured PORT-CHANNEL INTERFACE Assign the same VLT port-channel ID to interfaces on VLT peers to create a VLT port-channel. The no version of this command removes the VLT port-channel ID configuration. OS10(conf-if-po-10)# vlt-port-channel 1 Example (peer 2) OS10(conf-if-po-20)# vlt-port-channel 1 Supported Releases 10.2.0E or later vlt-mac Configures a MAC address for all peer switches in a VLT domain. Syntax vlt-mac mac-address Parameters mac-address - Enter a MAC address for the topology in nn:nn:nn:nn:nn:nn format. Default Not configured Command Mode VLT-DOMAIN Usage Information Use this command to minimize the time required to synchronize the default MAC address of the VLT domain on both peer devices when one peer switch reboots. If you do not configure a VLT MAC address, the MAC address of the primary peer is used as the VLT MAC address across all peers. This configuration must be symmetrical in all the Virtual Link Trunking 739