Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 418

ip ospf cost Changes the cost associated with the OSPF traffic on an interface. Syntax ip ospf cost cost Parameters cost - Enter a value as the OSPF cost for the interface (1 to 65335). Default Based on bandwidth reference Command Mode INTERFACE Usage Information Interface cost is based on the auto-cost command if not configured. This command configures OSPF over multiple vendors to ensure that all routers use the same cost. If you manually configure the cost, the calculated cost based on the reference bandwidth does not apply to the interface. The no version of this command removes the IP OSPF cost configuration. Example OS10(config)# interface vlan 10 OS10(conf-if-vl-1)# ip ospf cost 10 Supported Releases 10.2.0E or later ip ospf dead-interval Sets the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead. Syntax ip ospf dead-interval seconds Parameters seconds - Enter the dead interval value in seconds (1 to 65535). Default 40 seconds Command Mode INTERFACE Usage Information The dead interval is four times the default hello-interval by default. The no version of this command resets the value to the default. Example OS10(conf-if-vl-10)# ip ospf dead-interval 10 Supported Releases 10.2.0E or later ip ospf hello-interval Sets the time interval between the hello packets sent on the interface. Syntax ip ospf hello-interval seconds Parameters seconds - Enter the hello-interval value in seconds (1 to 65535). Default 10 seconds Command Mode INTERFACE Usage Information All routers in a network must have the same hello time interval between the hello packets. The no version of the this command resets the value to the default. Example OS10(conf-if-vl-10)# ip ospf hello-interval 30 Supported Releases 10.2.0E or later 418 Layer 3