Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 331
connection-retry-timer, confederation, Syntax, Parameters, Defaults, Command Modes, Usage Information
![]() |
View all Dell PowerSwitch S4112F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 331 highlights
connection-retry-timer Configures the timer to retry the connection to BGP neighbor or peer group. Syntax Parameters Defaults Command Modes connection-retry-timer retry-timer-value retry-timer-value - Enter the time interval in seconds, ranging from 10 to 65535. 60 seconds CONFIG-ROUTER-NEIGHBOR CONFIG-ROUTER-TEMPLATE Usage Information Example The no version of this command resets the timer to default value.. OS10(config-router-neighbor)# connection-retry-timer 1000 OS10(config-router-template)# connection-retry-timer 100 Supported Releases 10.3.0E or later confederation Configures an identifier for a BGP confederation. Syntax Parameters confederation {identifier as-num | peers as-number} • identifier as-num -Enter an AS number, from 0 to 65535 for 2 bytes, 1 to 4294967295 for 4 bytes, or 0.1 to 65535.65535 for dotted format. • peers as-number-Enter an AS number for peers in the BGP confederation, from 1 to 4294967295. Default Command Mode Usage Information Not configured ROUTER-BGP Configure your system to accept 4-byte formats before entering a 4-byte AS number. All routers in the Confederation must be 4-byte or 2-byte identified routers. You cannot have a mix of 2-byte and 4-byte identified routers. The autonomous system number you configure in this command is visible to the EBGP neighbors. Each autonomous system is fully meshed and contains a few connections to other autonomous systems. The next-hop (MED) and local preference information is preserved throughout the confederation. The system accepts confederation EBGP peers without a LOCAL_PREF attribute. OS10 sends AS_CONFED_SET and accepts AS_CONFED_SET and AS_CONF_SEQ. The no version of this command deletes the confederation configuration. NOTE: To configure these settings for a non default VRF instance, you must first enter the ROUTERCONFIG-VRF sub mode using the following commands: 1 Enter the ROUTER BGP mode using the router bgp as-number command. 2 From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example (Identifier) OS10(conf-router-bgp-2)# confederation identifier 1 Example (Peers) OS10(conf-router-bgp-2)# confederation peers 2 Layer 3 331
![](/manual_guide/products/dell-powerswitch-s3048on-os10-enterprise-edition-user-guide-release-10410-b76d862/331.png)