Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 496

host Assigns a host to a single IPv4 or IPv6 address pool for manual configurations. Syntax Parameters Default Command Mode Usage Information Example host A.B.C.D/A::B A.B.C.D/A::B - Enter the host IP address in A.B.C.D or A::B format. Not configured DHCP-POOL The host address is the IP address used by the client machine for DHCP. OS10(conf-dhcp-Dell)# host 20.1.1.100 Supported Releases 10.2.0E or later ip dhcp server Enters DHCP mode. Syntax ip dhcp server Parameters None Default Not configured Command Mode CONFIGURATION Usage Information This command is used to enter DHCP mode. Example OS10(config)# ip dhcp server OS10(conf-dhcp)# Supported Releases 10.2.0E or later ip helper-address Configure the DHCP server address. Forwards UDP broadcasts received on an interface to the DHCP server. You can configure multiple helper addresses per interface by repeating the same command for each DHCP server address. Syntax Parameters ip helper-address address [vrf vrf-name] • address - Enter the IPv4 address to forward UDP broadcasts to the DHCP server in the A.B.C.D format. • vrf vrf-name - (Optional) Enter the keyword vrf and then the name of the VRF through which the host address can be reached. Default Command Mode Usage Information Example (IPv4) Disabled INTERFACE The DHCP server is available on L3 interfaces only. The no version of this command returns the value to the default.The client-facing and server-facing interfaces must be in the same VRF. OS10(config)# interface eth 1/1/22 OS10(conf-if-eth1/1/22)# ip helper-address 20.1.1.1 vrf blue 496 System management