Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 251

Vlan 320 is up, line protocol is up Address is , Current address is Interface index is 69209184 Internet address is not set MTU 1532 bytes LineSpeed auto Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout: 240 Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface status change: Access mode An access port is an untagged member of only one VLAN. Configure a port in Access mode and configure which VLAN carries the traffic for that interface. If you do not configure the VLAN for a port in Access mode (or an access port), the interface carries traffic for VLAN 1 (default VLAN). Change the access port membership in a VLAN by specifying the new VLAN. You must create the VLAN before you can assign the port in Access mode to that VLAN. Use the no switchport access vlan command to reset to default VLAN. 1 Configure a port in INTERFACE mode. interface ethernet node/slot/port[:subport] 2 Set the interface to Switchport mode as access in INTERFACE mode. switchport mode access 3 Enter the VLAN number for the untagged port in INTERFACE mode. switchport access vlan vlan-id Configure port in access mode OS10(config)# interface ethernet 1/1/9 OS10(config-if-eth1/1/9)# switchport mode access OS10(config-if-eth1/1/9)# switchport access vlan 604 Show running configuration OS10# show running-configuration ... ! interface ethernet1/1/5 ... switchport access vlan 604 no shutdown ! interface vlan1 no shutdown ... Trunk mode A trunk port can be a member of multiple VLANs set up on an interface. A trunk port can transmit traffic for all VLANs. To transmit traffic on a trunk port with multiple VLANs, OS10 uses tagging or the 802.1q encapsulation method. 1 Configure a port in INTERFACE mode. interface ethernet node/slot/port[:subport] 2 Change the Switchport mode to Trunk mode in INTERFACE mode. switchport mode trunk Layer 2 251