Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 358

Supported Releases 10.2.0E or later show hash-algorithm Displays the hash-algorithm information. Syntax Parameters Default Command Mode Usage Information Example show hash-algorithm None Not configured EXEC None OS10# show hash-algorithm EcmpAlgo - crc LabAlgo - crc Supported Releases 10.3.0E or later IPv4 routing OS10 supports IPv4 addressing including variable-length subnetting mask (VLSM), Address Resolution Protocol (ARP), static routing, and routing protocols. With VLSM, you can configure one network with different masks. You can also use supernetting, which increases the number of subnets. You can add a mask to the IP address to separate the network and host portions of the IP address to add a subnet. You need to configure IPv4 routing for IP hosts to communicate with one another in the same network, or in different networks. Assign interface IP address You can assign primary and secondary IP addresses to a physical or logical interface to enable IP communication between the system and hosts connected to a specific interface. Assign one primary address and secondary IP addresses to each interface. By default, all ports are in the default VLAN-VLAN 1. 1 Enter the interface type information to assign an IP address in CONFIGURATION mode. interface interface • ethernet-Physical interface • port-channel-Port-channel ID number • vlan-VLAN ID number • loopback-Loopback interface ID • mgmt-Management interface 2 Enable the interface in INTERFACE mode. no shutdown 3 Remove the interface from the default VLAN in INTERFACE mode. no switchport 4 Configure a primary IP address and mask on the interface in INTERFACE mode. ip address ip-address mask [secondary] • ip-address mask-Enter the IP address in dotted decimal format-A.B.C.D. and mask in slash prefix-length format (/24). • secondary-Enter a secondary backup IP address for the interface. 358 Layer 3