Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 484

UFT commands hardware forwarding-table mode Select a mode to initialize the maximum scalability size. The available options are: scaled L2 MAC address table, scaled L3 routes table, or scaled L3 hosts table. Syntax hardware forwarding-table mode {scaled-l2 | scaled-l3-routes | scaled-l3-hosts} Use the no hardware forwarding-table mode command to set the UFT mode to default. Parameters • scaled-l2 -Maximize the MAC address table size. • scaled-l3-routes - Maximize the L3 routes table size. • scaled-l3-hosts - Maximize the L3 hosts table size Defaults Command Mode Usage Information Example The default parameters vary according to the platform. See UFT modes. CONFIGURATION Configure the sizes of internal L2 and L3 forwarding tables of the switch as per the requirements of the network environment. You need to reload the switch to apply the changes. OS10(config)# hardware forwarding-table mode scaled-l3-hosts Supported Releases 10.3.0E or later hardware l3 ipv6-extended-prefix Configures the maximum number of route entries for IPv6 extended prefix route. Syntax Parameters Defaults Command Mode Usage Information Example hardware l3 ipv6-extended-prefix prefix-number prefix-number -Enter the maximum number of route entries for IPv6 extended prefix route. The options available are: 1024, 2048, or 3072. None CONFIGURATION Save and Reload the switch for the settings to become effective. The no version of the command removes the IPv6 extended prefix route configuration. OS10# configure terminal OS10(config)# hardware l3 ipv6-extended-prefix 2048 % Warning: IPv6 Extended Prefix Installation will be applied only after a save and reload. OS10(config)# do write memory OS10(config)# reload Supported Releases 10.4.1.0 or later 484 UFT modes