Dell PowerVault MD3260i CLI Guide - Page 158

Parameter logFile Description Name of the file to which to save the log sense data. You must put quotation marks (" ") around the file name. Save Physical Disk Channel Fault Isolation Diagnostic Status This command saves the physical disk channel fault isolation diagnostic data that is returned from the start physical disk channel fault isolation diagnostics command. You can save the diagnostic data to a file as standard text or as XML. See Start Physical Disk Channel Fault Isolation Diagnostics for more information. Syntax save physicalDiskChannel [(1 | 2 )] faultDiagnostics file="filename" Parameters Parameter Description physicalDiskChannel The identifier number of the physical disk channel for which you want to save the diagnostics data. Valid values for the identifier number are 1 or 2. Enclose the identifier number in square brackets ([ ]). file The name of the file in which you are storing the results of the fault isolation diagnostics test on the drive channel. Enclose the name in double quotation marks (" "). NOTE: A file extension is not automatically appended to the saved file. You must specify the applicable format suffix for the file. If you specify a file extension of .txt, then the output is in a text file format. If you specify a file extension of .xml, then the output is in an XML file format. Save Physical Disk Log This command saves the log sense data to a file. Log sense data is maintained by the storage array for each physical disk. Syntax save allPhysicalDisks logFile="filename" Parameter Parameter logFile Description Name of the file to which to write the log sense data. You must put quotation marks (" ") around the file name. Save RAID Controller Module NVSRAM This command saves a copy of the RAID controller module NVSRAM values to a file. This command saves all regions. Syntax save controller [(0 | 1)] NVSRAM file="filename" 158