Dell PowerVault MD3260i CLI Guide - Page 215
Start Virtual Disk Initialization, Stop Configuration Database Diagnostic, Stop Disk Group Blink
View all Dell PowerVault MD3260i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
NOTE: This command is for IPv4 only. Syntax start storageArray isnsServerRefresh Parameter None. NOTE: If you used the set storageArray isnsIPv4ConfigurationMethod command to set the configuration but did not set the configuration to DHCP, running the start storageArray isnsServerRefresh returns an error. Start Virtual Disk Initialization This command starts the formatting of a virtual disk in a storage array. NOTE: Initializing a virtual disk is a long-running operation that you cannot stop. Syntax start virtualDisk [virtualDiskName] initialize Parameter Parameter Description virtualDisk Name of the virtual disk for which to start the formatting. You must put brackets ([ ]) around the virtual disk name. If the virtual disk name has special characters, you must also put quotation marks (" ") around the virtual disk name. Stop Configuration Database Diagnostic This command stops the diagnostic test to validate the configuration database in the controller firmware that was started by the start storageArray configDbDiagnostic command. Syntax Stop storageArray configDbDiagnostic Parameters None. NOTE: The controller firmware returns a confirmation that the diagnostic test was cancelled. In addition, the database configuration diagnostic test can be started through the storage management software GUI but cannot be stopped through the storage management software GUI. If you want to stop a running diagnostic test, you must use the stop storageArray configDbDiagnostic command. Stop Disk Group Blink This command turns off the indicator LED on the physical disk that was turned on by the start diskGroup blink command. Syntax stop diskGroup blink Parameters 215