Dell PowerVault MD3260i CLI Guide - Page 29
IPV4Priority, Syntax Values
View all Dell PowerVault MD3260i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Recurring Syntax nvsram-bit-setting ipv4-address ipv6-address autoconfigure-vols-attr-value-list autoconfigure-vols-attr-value-pair create-virtual-disk-copy-attr-value-list create-virtual-disk-copy-attr-value-pair recover-raid-virtual-disk-attr-value-list recover-raid-virtual-disk-attr-value-pair Table 8. Range of Values for Recurring Syntax Elements Recurring Syntax IPV4Priority IPV4VlanID IPV6Priority IPV6VlanID Syntax Value nvsram-mask, nvsram-value (0x hexadecimal, 0x hexadecimal | integer-literal) (0-255).(0-255).(0-255).(0-255) (0-FFFF):(0-FFFF):(0-FFFF): (0-FFFF):(0-FFFF):(0-FFFF): (0-FFFF):(0-FFF) autoconfigure-vols-attr-value-pair {autoconfigure-vols-attr-value-pair} physicalDiskType=physical disk-type| raidLevel=raid-level | diskGroupWidth=integer-literal | diskGroupCount=integer-literal | virtualDisksPerGroupCount=integerliteral| hotSpareCount=integer-literal | segmentSize=segment-size-spec NOTE: The physicalDiskType parameter is not required if only one type of physical disk is in the storage array. If you use the physicalDiskType parameter, you must also use the hotSpareCount and diskGroupWidth parameters. If you do not use the physicalDiskType parameter, the configuration defaults to SAS physical disks. NOTE: The virtualDisksPerGroupCount parameter is the number of equalcapacity virtual disks per disk group. create-virtual-disk-copy-attr-value-pair {create-virtual-disk-copy-attr-value-pair} copyPriority=highest | high | medium | low | lowest | targetReadOnlyEnabled=boolean recover-raid-virtual-disk-attr-value-pair {recover-raid-virtual-disk-attr-value-pair} owner=(0 | 1) Syntax Values 0 to 7 1 to 4094 0 to 7 1 to 4094 29