Dell PowerVault MD3260i CLI Guide - Page 30
Usage Guidelines, Adding Comments To A Script File, IPV6RetransmitTime
View all Dell PowerVault MD3260i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Recurring Syntax IPV6HopLimit IPV6NdDetectDuplicateAddress IPV6NdReachableTime IPV6RetransmitTime IPV6NDTimeOut maxFramePayload tcpListeningPort (tcp-port-id) Syntax Values 0 to 255 (default value is 64) 0 to 256 0 to 65535 (default value is 30000 milliseconds) 0 to 65535 (default value is 1000 milliseconds) 0 to 65535 (default value is 3000 milliseconds) 1500 NOTE: The maxFramePayload parameter is shared between IPv4 and IPv6. The payload portion of a standard Ethernet frame is set at 1500 bytes, and a jumbo Ethernet frame is set at 9000 bytes. When using jumbo frames, make sure that all of the devices contained in the network path can handle the larger frame size. 3260, or 49,152 to 65,536 The default value is 3260. Usage Guidelines The following list provides guidelines for writing script commands on the command line: • You must end all commands with a semicolon (;). • You can enter more than one command on a line, but you must separate each command with a semicolon (;). • You must separate each base command and its associated primary and secondary parameters with a space. • The script engine is case sensitive. • You can add comments to your scripts to make it easier for you and future users to understand the purpose of the script commands. (For information on how to add comments, see Adding Comments To A Script File). NOTE: While the CLI and script commands are not case sensitive, user labels (such as for virtual disk, hosts, or host ports) are case sensitive. If you try to map to an object identified by a user label, you must enter the user label exactly as it is defined, or the CLI and script commands fails. NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation. NOTE: The capacity parameter returns an error if you specify a value greater than or equal to 10 without a space separating the numeric value and its unit of measure. (For example, 10 GB returns an error, but 10 GB does not return an error). Adding Comments To A Script File You can add comments to a script file in three ways: • The script engine interprets as a comment any text typed after two forward slashes (/ /) until an end‑of‑line character is reached. If the script engine does not find an end‑of‑line character in the script after processing a 30