Dell PowerVault MD3260i CLI Guide - Page 170
Set Host Channel, Host Does Not Have Individual Virtual
View all Dell PowerVault MD3260i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Parameter host hostGroup userLabel hostType Description The name of the host that you want to assign to a host group. Enclose the host name in square brackets ([ ]). If the host name has special characters, you must also enclose the host name in double quotation marks (" "). The host group to which you want to assign the host. (The following table defines how the command runs if the host does or does not have individual virtual disk-to-LUN mappings.) Enclose the host group name in double quotation marks (" "). The defaultGroup is the host group that contains the host to which the virtual disk is mapped. The new host name. Enclose the host name in double quotation marks (" "). The index label or number of the host type for the HBA host port. Use the show storageArray hostTypeTable command to generate a list of available host type identifiers. If the host type has special characters, enclose it in double quotation marks (" "). Host Group Parameter hostGroupName none defaultGroup Host Has Individual Virtual Disk-toLUN Mappings Host Does Not Have Individual Virtual Disk-to-LUN Mappings The host is removed from the present host group and is placed under the new host group defined by hostGroupName. The host is removed from the present host group and is placed under the new host group defined by hostGroupName. The host is removed from the host The host is removed from the present group as an independent partition and host group and is placed under the is placed under the root node. default group. The command fails. The host is removed from the present host group and is placed under the default group. NOTE: When you use this command, you can specify one or more of the optional parameters. You do not, however, need to use all of the parameters. NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation. Set Host Channel This command defines the loop ID for the host channel. Syntax set hostChannel [hostChannelNumber] preferredID=portID Parameters 170