Dell Studio Hybrid D140G Studio Hybrid Service Manual - Page 3

Back to Contents Page Replacing the Back Panel Dell™ Studio Hybrid Service Manual Removing the Back Panel Installing the Back Panel CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. Removing the Back Panel 1. Follow the procedures in Before You Begin. 2. Remove the computer cover (see Removing the Computer Cover). 3. Remove the drive cage (see Removing the Drive Cage). NOTICE: Carefully note the routing of each cable before you disconnect it, so that you re-route the cable correctly. An incorrectly routed or a disconnected cable could lead to computer problems. 4. Disconnect the SYS_FAN1 cable from the system board, the black antenna cable from the WLAN card, and the flex-cable from the back I/O board. 5. Remove the two screws on either side of the chassis. 6. Spread the tabs apart on either side of the back panel and gently pull the back panel away from the chassis. 1 back panel . 2 latches (2) 7. Spread the tabs apart and gently pull the RF receiver cable away from the back panel. 1 latches 2 tabs Installing the Back Panel