Epson TM-L90 Technical Reference - Page 107
Handling - troubleshooting
View all Epson TM-L90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Chapter 7 Handling TM-L90/TM-L90 Peeler Model Technical Reference Guide 7.1 Maintenance 7.1.1 Cleaning the autocutter (TM-L90 only) If label paper adhesive has stuck to the autocutter, it may dull the cutting edge. In such a case, clean the cutter blade using the following procedure. 1. Turn off the power. 2. Disconnect the printer from the power connector. 3. Open the roll paper cover. Note: If the roll paper cover will not open, take action in accordance with the troubleshooting of the autocutter (page 118). 4. As shown below, remove the adhesive residues accumulated on the cutter blade on the roll paper cover side with a cutter knife or similar tool. Adhesive adheres on cutter blade Handling 107
Handling
107
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Chapter 7
Handling
7.1
Maintenance
7.1.1
Cleaning the autocutter (TM-L90 only)
If label paper adhesive has stuck to the autocutter, it may dull the cutting edge. In such a case,
clean the cutter blade using the following procedure.
1.
Turn off the power.
2.
Disconnect the printer from the power connector.
3.
Open the roll paper cover.
Note:
If the roll paper cover will not open, take action in accordance with the troubleshooting of the
autocutter (page 118).
4.
As shown below, remove the adhesive residues accumulated on the cutter blade on the roll
paper cover side with a cutter knife or similar tool.
Adhesive adheres on cutter blade