Epson TM-L90 Technical Reference - Page 129

3: Basic Serial Interface Settings 4: Advanced Interface Settings 6: Interface Reset Signal 7: Paper Width 8: Other settings 1 9: Other settings 2 11: Select label TM-L90/TM-L90 Peeler Model Technical Reference Guide [Baud rate set up] 2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps, 57600 bps, 115200 bps [Data bits / Handshaking / Parity set up] 8 bits / DTR/DSR / none 8 bits / DTR/DSR / even 8 bits / DTR/DSR / odd 8 bits / XON/XOFF / none 8 bits / XON/XOFF / even 8 bits / XON/XOFF / odd 7 bits / DTR/DSR / none 7 bits / DTR/DSR / even 7 bits / DTR/DSR / odd 7 bits / XON/XOFF / none 7 bits / XON/XOFF / even 7 bits / XON/XOFF / odd [Buffer Capacity / Receive Error / Handshaking Operation (Busy Condition)] 4 Kbytes / prints '?' / Off-line or Receive buffer full 4 Kbytes / prints '?' / Receive buffer full 4 Kbytes / ignore / Off-line or Receive buffer full 4 Kbytes / ignore / Receive buffer full 45 bytes / prints '?' / Off-line or Receive buffer full 45 bytes / prints '?' / Receive buffer full 45 bytes / ignore / Off-line or Receive buffer full 45 bytes / ignore / Receive buffer full [Serial #25 / Serial #6] Disable / Disable Disable / Enable Enable / Disable Enable / Enable 38 mm, 58 mm, 60 mm, 70 mm, 80 mm [Selection of the PAPER OUT LED status when a paper near-end is detected] On, Off [Recovery selection when paper layout error occurs] DLE ENQ DLE ENQ or Main cover open/close DLE ENQ or press down PAPER FEED button DLE ENQ or Main cover open/close or press down PAPER FEED button [Select manual feed operation] Paper feed to the print starting position Paper feed to the peel position [Select automatic measurement of maximum length for paper] 160 mm, 300 mm [Select moving to the print starting position when power is turned on] moves to starting position does not move Appendix 129