Epson TM-L90 Technical Reference - Page 139

Printing Area Thermal Paper TM-L90/TM-L90 Peeler Model Technical Reference Guide Printable Area (For Thermal Paper) Note: The printable area may be out of alignment by 2 mm {0.08"} maximum (left or right), due to the paper position or tolerance of parts. Therefore, the print area must be set in the range of more than 2 mm from the edges of the paper. To make the margin for both sides safely, it is recommended to set a margin of 2.6 mm {0.1"} or more, as shown in figure above. Paper Width and Printable Area Paper width (mm) (80) (70) (65) (60) (58) (50) (45) (38) Printable area (mm) 72 64 59 54 52 44 39 32 Left margin (mm) 2.65 2.65 2.65 2.65 2.65 2.65 2.65 2.65 Right margin (mm) 4.85 2.85 2.85 2.85 2.85 2.85 2.85 2.85 Positioning dot number 1-576 1-512 1-472 1-432 1-416 1-352 1-312 1-256 Total number of dots 576 512 472 432 416 352 312 256 Numeric values used above table are center values in designing. Paper width is only for nominal dimension. The values in parentheses are the maximum value for the paper tolerance. Appendix 139