Epson TM-L90 Technical Reference - Page 128
Setting items of TM-L90 Peeler other than 39* models
![]() |
View all Epson TM-L90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
11: Label Settings 12: Paper Feed Settings 13: Other Settings 1: Automatic measurement of maximum length 160 mm, 300 mm 2: Moving to the print start position Disabled, Enabled 5: Select manual feed operation in Paper feed to the print starting position, Paper feed to the Continuous issue mode peel position 2: Interface Settings 1: Receive Buffer 4 KB, 45 bytes Capacity 2: BUSY Condition Receive Buffer Full or Offline, Receive Buffer Full 3: Auto Line Feed Always disabled, Always enabled 4: State to cancel Not BUSY = 256 bytes, Not BUSY = 138 bytes buffer BUSY 5: Error Signal Enabled, Disabled 3: Near-End LED Disabled, Enabled 4: Transmit the power ON information Does not transmit, Transmit 5: Recovery layout error DLE ENQ DLE ENQ or Main cover open/close DLE ENQ or press down PAPER FEED button DLE ENQ or Main cover open/close or press down PAPER FEED button Setting items of TM-L90 Peeler other than 39* models See "Memory Switch Settings" on page 44 for the procedures for the memory switch setting mode. Setting Items 1st page 2nd page 2: Paper, Print Density 1: Monochrome 2: Two color Options * The initial setting is underlined. [Print density set up] 70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%, 120%, 125%, 130%, 135%, 140% [Print density set up] 70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%, 120%, 125%, 130%, 135%, 140% 128 Appendix
![](/manual_guide/products/epson-tml90-technical-reference-9b83b36/128.png)