Epson TM-L90 Technical Reference - Page 125

TM-L90/TM-L90 Peeler Model Technical Reference Guide Setting items of TM-L90 other than 4** models See "Memory Switch Settings" on page 44 for the procedures for the memory switch setting mode. Setting Items 1st page 2nd page 1: Auto Cutter 2: Paper, Print Density 1: Monochrome 2: Two color 3: Basic Serial Interface Settings 4: Advanced Interface Settings 6: Interface Reset Signal 7: Paper Width Options * The initial setting is underlined. Install, Uninstalled [Print density set up] 70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%, 120%, 125%, 130%, 135%, 140% [Print density set up] 70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%, 120%, 125%, 130%, 135%, 140% [Baud rate set up] 2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps, 57600 bps, 115200 bps [Data bits / Handshaking / Parity set up] 8 bits / DTR/DSR / none 8 bits / DTR/DSR / even 8 bits / DTR/DSR / odd 8 bits / XON/XOFF / none 8 bits / XON/XOFF / even 8 bits / XON/XOFF / odd 7 bits / DTR/DSR / none 7 bits / DTR/DSR / even 7 bits / DTR/DSR / odd 7 bits / XON/XOFF / none 7 bits / XON/XOFF / even 7 bits / XON/XOFF / odd [Buffer Capacity / Receive Error / Handshaking Operation (Busy Condition)] 4 Kbytes / prints '?' / Off-line or Receive buffer full 4 Kbytes / prints '?' / Receive buffer full 4 Kbytes / ignore / Off-line or Receive buffer full 4 Kbytes / ignore / Receive buffer full 45 bytes / prints '?' / Off-line or Receive buffer full 45 bytes / prints '?' / Receive buffer full 45 bytes / ignore / Off-line or Receive buffer full 45 bytes / ignore / Receive buffer full [Serial #25 / Serial #6] Disable / Disable Disable / Enable Enable / Disable Enable / Enable 38 mm, 58 mm, 60 mm, 70 mm, 80 mm Appendix 125