Epson TM-L90 Technical Reference - Page 159
Black mark position
View all Epson TM-L90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
TM-L90/TM-L90 Peeler Model Technical Reference Guide Black mark position I The black mark positions on the paper to be manufactured must meet the requirements in the figure below. The reflective rates of the black mark portions 1 and label portions 2 must meet the combinations shown in the table below (the reflective rate is measured using the back of the paper, the non-printing side): Reflecting rate for black mark portion 1 17% 16% 15% 14% 13% Less Reflecting rate for label portion 2 90% 85% 80% 75% 70% More NOTE: Reflective rates are measured by the Macbeth PCM-II (Filter D) meter. NOTE: Dimensions marked with * must be kept. Appendix 159
Appendix
159
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Black mark position I
The black mark positions on the paper to be manufactured must meet the requirements in the
figure below. The reflective rates of the black mark portions 1 and label portions 2 must meet the
combinations shown in the table below (the reflective rate is measured using the back of the
paper, the non-printing side):
NOTE: Reflective rates are measured by the Macbeth PCM-II (Filter D) meter.
NOTE: Dimensions marked with * must be kept.
Reflecting rate for black mark portion 1
17%
16%
15%
14%
13%
Less
Reflecting rate for label portion 2
90%
85%
80%
75%
70%
More