HP 170X HP JetDirect 170X - Installation and Configuration Guide - Page 60

Table 8.2 Message General HP Jetdirect Messages (2 of 15) Description CF ERR - LINE TOO LONG A line being processed in the TFTP configuration file was longer than the HP Jetdirect print server could accept. CF ERR - MISSING A line in the TFTP configuration file was missing a PARAM required parameter. CF ERR - TRAP LIST EXCEEDED The TFTP configuration file specified too many trap destination list entries using the "trap-destination:" keyword. CF ERR UNKNOWN KEYWORD A TFTP configuration file line contained an unknown keyword. CONFIGURATION ERROR The configuration information for the NetWare functions is not stored correctly on the HP Jetdirect print server. Rerun the installation software to reconfigure. If this error persists, there may be a problem with the HP Jetdirect print server. CRC ERROR Check the network topology and verify all cable segments. Check for damaged cables. DHCP NACK The server has not acknowledged the DHCP request. Rerun the configuration software to restart the process. DISCONNECTED The Novell NetWare protocol is disconnected. Check the server and the print server. PORT SELECT DISCONNECTED The port on the card that was automatically sensed as having the cable attached. No cable detected. DISCONNECTING SPX TIMEOUT The SPX connection to the print server was lost after the connection had been made. This indicates a possible network problem, or a problem with the print server. Make sure all cables and routers are functioning correctly. Try restarting the print server. Config. Page 8 Messages HP Jetdirect Configuration Page Messages 8-5