HP 3015 HP LaserJet 3015 All-in-One - User Guide - Page 60
To reduce or enlarge copies for the current job, To change the default copy size, Ltr > A4=97
View all HP 3015 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Note To reduce or enlarge copies for the current job To reduce or enlarge copies for the current job only, use the following instructions. 1. On the device control panel, press REDUCE/ENLARGE. 2. Select the size to which you would like to reduce or enlarge the copies in this job. You can select: ● Original=100% ● Lgl > Ltr=78% ● Lgl > A4=83% ● A4 > Ltr=94% ● Ltr > A4=97% ● Full Page=91% ● 2 pages/sheet ● 4 pages/sheet ● Custom: 25-400% If you select Custom: 25-400%, type a percentage by using the alphanumeric buttons. If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or landscape). 3. Press START/COPY to save the selection and immediately start the copy job, or press MENU/ ENTER to save the selection without starting the job. The change in the setting remains active for about two minutes after the copy job has been completed. During this time, Settings=Custom appears on the device control panel display. To change the default copy size The default copy size is the size to which copies are normally reduced or enlarged. If you keep the factory-default size setting of Original=100%, all copies will be the same size as the original document. 1. Press MENU/ENTER. 2. Use the < or the > button to select Copy setup, and then press MENU/ENTER. 3. Use the < or the > button to select Def. Redu/Enlrg, and then press MENU/ENTER. 50 Chapter 4 Copying ENWW