HP 303B Maintenance & Service Guide: HP 303B Microtower Business PC - Page 24

Securing the Expansion Cards and Slot Covers, Removal and Replacement Procedures Microtower MT Chassis

Get HP 303B - Minitower PC PDF manuals and user guides View all HP 303B manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

8. To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis so that the bottom of the bracket on the card slides into the small slot on the chassis. Press the card straight down into the expansion socket on the system board. Figure 2-11 Installing an Expansion Card NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 9. Replace the slot cover lock and secure it in place with the screw that was previously removed. Figure 2-12 Securing the Expansion Cards and Slot Covers NOTE: The appearance of the power supply varies based on model. 10. Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed. 11. Replace the computer access panel. 16 Chapter 2 Removal and Replacement Procedures Microtower (MT) Chassis

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
8.
To install a new expansion card, hold the card just above the expansion socket on the system
board then move the card toward the rear of the chassis so that the bottom of the bracket on the
card slides into the small slot on the chassis. Press the card straight down into the expansion
socket on the system board.
Figure 2-11
Installing an Expansion Card
NOTE:
When installing an expansion card, press firmly on the card so that the whole
connector seats properly in the expansion card slot.
9.
Replace the slot cover lock and secure it in place with the screw that was previously removed.
Figure 2-12
Securing the Expansion Cards and Slot Covers
NOTE:
The appearance of the power supply varies based on model.
10.
Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
11.
Replace the computer access panel.
16
Chapter 2
Removal and Replacement Procedures Microtower (MT) Chassis