HP 9050 HP LaserJet 9040mfp/9050mfp - User Guide - Page 156

Message Explanation or recommended action TOO MANY PAGES IN JOB TO FINISH For help touch OK The external device received too many pages to perform the requested finishing process. TOO MANY PAGES IN JOB TO STAPLE For help touch OK The print job is too large to staple. The job will be completed unstapled. TOO MANY PAGES TO MAKE BOOKLET The page content is too large to be saddle stitched. Verify that the job is within specifications to be saddle stitched. See the User's Guide that came with the output device for more information. UNABLE TO STORE JOB A job cannot be stored on the MFP because of a memory, disk, or configuration problem. UNSUPPORTED DATA ON [FS] DIMM IN SLOT X To clear touch OK. The DIMM in the specified slot contains unsupported data. Username or password is incorrect. Please re-enter. The user name or password is incorrect or mis typed. Retype the user name and password. Waiting for tray The tray is lifting the paper to the top of the tray for correct feeding. xx to lift Windows Login Required to use this feature: Provide Windows network credentials to access the digital sending feature. 10.xx.yy SUPPLY MEMORY ERROR The MFP cannot read or write to at least one supply e-label or an e-label is missing from a supply. Reinstall the supply, or install a new supply. 11.xx Internal clock error To continue touch OK There is a problem with the MFP's real time clock. The MFP will prompt the user to set the date and time whenever the product is turned off, and then turned on. If the error persists, replace the formatter. 13.xx.yz JAM IN [LOCATION] Remove jammed media from the specified location (see Clearing jams). Open and close the front door to clear the message. If the message persists after all jams have been cleared, a sensor might be stuck or broken. Contact an HP-authorized service or support provider (see the HP support flyer, or go to www.hp.com/support/lj9040mfp or www.hp.com/ support/lj9050mfp). 152 Chapter 10 Problem solving ENWW