HP NetServer LXr Pro8 HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgr - Page 15
Installation in LC 3 and LH 3/3r
View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3 Installation in LC 3 and LH 3/3r Installation Overview NOTE If you install two processor modules, use processor upgrade kits with the same HP product number. If you add a second processor module, match it to the existing processor module. (Your HP reseller can advise you about matching processor modules.) Add the new processor module to the secondary processor position. To avoid flexing the system board, remove it before upgrading processor modules in HP NetServer LC 3 and LH 3/3r. Do the following: 1. Power down the NetServer, and disconnect it. 2. Remove the front bezel and covers. 3. Remove the system board. 4. Remove the existing processor modules, if necessary. 5. Install the new processor modules and any VRMs required. 6. Install a terminator board for a single-processor NetServer, if not already present. 7. Set the system switches, and attach label to system board if necessary. 8. Reinstall the system board. 9. Replace all covers and the front bezel. 10. Reconnect the NetServer. 11