HP NetServer LXr Pro8 HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgr - Page 23

Removing a Processor Module Without a Processor Retaining Latch, CAUTION

Get HP NetServer LXr Pro8 PDF manuals and user guides View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Chapter 3 Installation in LC 3 and LH 3/3r Removing a Processor Module Without a Processor Retaining Latch To remove a processor module that does not have a processor retaining latch: 1. Press in on each processor module release latch until it remains in (see Figure 3-5). If the latch does not stay in, you must hold it in while removing the module. Processor Eject Lever Processor Mounting Bracket Processor Module Release Latch (Two Places) Figure 3-5. Removing a Processor Module Without a Processor Retaining Latch 2. Lift up on the processor ejector lever until the processor pops out of the processor slot (see Figure 3-5). CAUTION Do not move the processor ejector lever beyond its limit (about 25-30 degree angle from the original position). The ejector lever may break if forced. 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
Chapter 3
Installation in LC 3 and LH 3/3r
19
Removing a Processor Module Without a Processor Retaining Latch
To remove a processor module that does
not
have a processor retaining latch:
1.
Press in on each processor module release latch until it remains in (see
Figure 3-5). If the latch does not stay in, you must hold it in while
removing the module.
Processor Eject Lever
Processor
Mounting
Bracket
Processor Module
Release Latch (Two Places)
Figure 3-5.
Removing a Processor Module Without a Processor
Retaining Latch
2.
Lift up on the processor ejector lever until the processor pops out of the
processor slot (see Figure 3-5).
CAUTION
Do not move the processor ejector lever beyond its limit
(about 25-30 degree angle from the original position). The
ejector lever may break if forced.