HP NetServer LXr Pro8 HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgr - Page 42
Remove the HP NetServer LPr from the Rack, Remove the Cover
View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Chapter 4 Installation in E 60 and LPr Remove the HP NetServer LPr from the Rack For HP NetServer LPr, refer to your NetServer documentation and rack documentation to remove the front bezel and remove the NetServer from the rack. WARNING Do the following to prevent the rack enclosure from tipping over: • Extend the anti-tip foot, or verify that the anti-tip feature is installed. • Verify that the leveler feet are lowered. • Do not extend more than one piece of equipment at a time out from the front of the rack. Failure to take these precautions could result in serious injury and equipment damage. Remove the Cover Refer to your NetServer documentation to remove the cover to gain access to the system board. NOTE In an HP NetServer E 60, unsnap the cooling duct and swing it away from the processor modules. 38