HP NetServer LXr Pro8 HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgr - Page 24
Removing a Processor Module With a Processor Retaining Latch
View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Chapter 3 Installation in LC 3 and LH 3/3r 3. Remove the processor module from the mounting bracket assembly. Removing a Processor Module With a Processor Retaining Latch To remove a processor module that HAS a retaining latch: 1. Squeeze the two tabs on the outer edge of the processor retaining latch, as shown in Figure 3-6. Disengage the two retaining hooks from the other side of the processor ejector lever. Disengage Two Hooks from Processor Ejector Lever Processor Ejector Lever Figure 3-6. Squeeze Tabs on Processor Retaining Latch, and Disengage Hooks from Processor Ejector Lever 20
Chapter 3
Installation in LC 3 and LH 3/3r
20
3.
Remove the processor module from the mounting bracket assembly.
Removing a Processor Module With a Processor Retaining Latch
To remove a processor module that HAS a retaining latch:
1.
Squeeze the two tabs on the outer edge of the processor retaining latch, as
shown in Figure 3-6. Disengage the two retaining hooks from the other
side of the processor ejector lever.
Disengage Two Hooks from
Processor Ejector Lever
Processor Ejector Lever
Figure 3-6.
Squeeze Tabs on Processor Retaining Latch, and Disengage
Hooks from Processor Ejector Lever