HP NetServer LXr Pro8 HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgr - Page 17

Disconnect the NetServer

Get HP NetServer LXr Pro8 PDF manuals and user guides View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Chapter 3 Installation in LC 3 and LH 3/3r Disconnect the NetServer 1. Bring down the network properly. If necessary, shut down the network operating system. 2. Turn off power to the HP NetServer and the monitor. 3. Disconnect all cables, as follows: ◊ DISCONNECT THE AC POWER CORD and all telephone cables from the HP NetServer. ◊ Disconnect all cables attached to the system board at the rear of the NetServer (such as mouse, keyboard, and other cables). WARNING Before removing the cover, always disconnect the power cord and unplug telephone cables. Disconnect telephone cables to avoid exposure to shock hazard from telephone ringing voltages. Disconnect the power cord to avoid exposure to high energy levels that may cause burns when parts are short-circuited by metal objects such as tools or jewelry. Note that the power switch does not turn off the standby power. Disconnect the power cord to turn off standby power. CAUTION Wear a wrist strap and use a static-dissipating work surface connected to the chassis when handling components. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
Chapter 3
Installation in LC 3 and LH 3/3r
13
Disconnect the NetServer
1.
Bring down the network properly. If necessary, shut down the network
operating system.
2.
Turn off power to the HP NetServer and the monitor.
3.
Disconnect all cables, as follows:
◊
DISCONNECT THE AC POWER CORD
and all telephone cables from
the HP NetServer.
◊
Disconnect all cables attached to the system board at the rear of the
NetServer (such as mouse, keyboard, and other cables).
WARNING
Before removing the cover, always disconnect the power cord
and unplug telephone cables. Disconnect telephone cables to
avoid exposure to shock hazard from telephone ringing
voltages. Disconnect the power cord to avoid exposure to
high energy levels that may cause burns when parts are
short-circuited by metal objects such as tools or jewelry.
Note that the power switch does
not
turn off the standby
power. Disconnect the power cord to turn off standby power.
CAUTION
Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components.