HP Omni Pro 110 Maintenance and Service Guide: HP Omni Pro 110 All-in-One PC - Page 53
Webcam Module
View all HP Omni Pro 110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Webcam Module Description Webcam module Spare part number 651586-001 The webcam module is located at the top of the computer. It is located below an upper cover, is secured with two screws, and has one connector. To remove the webcam module: 1. Prepare the computer for disassembly (see Preparing to Disassemble the Computer on page 28). 2. Position the computer with the top rear facing you. 3. Remove the small rear cover (see Small Rear Cover on page 29). 4. Remove the stand (see Stand on page 30). 5. Remove the right rear cover (see Right Rear Cover on page 36). 6. Remove the heat sink (see Heat Sink (Thermal Module) on page 39). 7. To remove the upper cover that allows access to the webcam, remove the two screws (1) that secure the cover to the computer, and then rotate the cover up and off the computer (2). Figure 7-16 Removing the upper cover 8. Remove the two screws that secure the webcam module to the computer. Figure 7-17 Removing the webcam module screws Webcam Module 45