HP Omni Pro 110 Maintenance and Service Guide: HP Omni Pro 110 All-in-One PC - Page 69
Front Bezel
View all HP Omni Pro 110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
11. Remove the cables from the clips built into the computer. 12. Remove the drive connector from the computer. To install the hard drive connector, reverse the removal procedures. Front Bezel Description Display bezel Spare part number 651599-001 The front bezel is located on the front of the computer and secured with 6 screws and tabs on each side. You must remove the power button assembly from the bezel to remove the bezel from the computer. To remove the front bezel: 1. Prepare the computer for disassembly (see Preparing to Disassemble the Computer on page 28). 2. Remove the small rear cover (see Small Rear Cover on page 29). 3. Remove the stand (see Stand on page 30). 4. Remove the right rear cover (see Right Rear Cover on page 36). 5. Remove the heat sink (see Heat Sink (Thermal Module) on page 39). 6. Remove the rear cover (see Rear Cover on page 47). 7. Remove the system board shield (see System Board Shield on page 52). 8. Remove the system board (see System Board on page 57). 9. Remove the stand bracket (see Stand Bracket on page 59). Front Bezel 61