HP Surestore Tape Library Model 20/700 HP Surestore Bridge FC 2/1 LV and FC 4/ - Page 106

Telnet This setup can be useful for remote management of the bridge via Telnet, the HTTP (web browser) interface, or any of the other remote interfaces. Because the method of setting up a lease reservation varies depending on the DHCP server being used, it is recommended you contact your Network Administrator for assistance. For more information about enabling DHCP on the FC 2/1 LV and FC 4/1 HV, see Appendix D. The FC 2/1 LV and FC 4/1 HV is capable of holding Telnet sessions for management purposes. Menus accessed via the serial port are disabled when a Telnet session is connected. To open a Telnet session, the IP address of the FC 2/1 LV and FC 4/1 HV and a Telnet client utility are required. Note Rebooting the bridge will close the telnet session. After the bridge reboots and completes POST, the user will have to restart or re-open the Telnet session. Note Resetting a bridge to factory defaults will render the bridge unable to use a gateway until the IP address and gateway are re-configured via the serial interface. This will result in a loss of connectivity during a Telnet session. From most Windows 9x and NT systems, users can start a Telnet session from the DOS (or Command) prompt using the following steps: 1. From the Windows Start menu, open the DOS (or Command) prompt window. 2. At the '>' prompt, enter the following command TELNET where is the IP address of the FC 2/1 LV and FC 4/1 HV. This will start a Telnet session window for the FC 2/1 LV and FC 4/1 HV. 3. Enter [root] for the default user name and [password] for the default password. It is recommended that you change the user name and password as soon as possible. See Ethernet Connection on page 64 for more information on setting up user names and passwords. 108 Management Interfaces Chapter 5