HP Surestore Tape Library Model 20/700 HP Surestore Bridge FC 2/1 LV and FC 4/ - Page 183
Verify the Fibre Channel configurations., fault, Fibre Channel, Ethernet
![]() |
View all HP Surestore Tape Library Model 20/700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
■ The fault indicator is lit when the bridge detects a fault condition. Faults can occur as a result of a power-on self test (POST), or operational failure. It is normal for this indicator to flash on when the bridge is powered up or reset. If the fault indicator stays lit, contact an HP service representative. ■ The Fibre Channel indicator shows Fibre Channel activity when lit. If this indicator fails to light at all or stays continually lit without corresponding SCSI bus activity, it may indicate a problem with the Fibre Channel link. Verify the Fibre Channel configurations. ■ The Ethernet indicator signifies Ethernet activity when lit. If the light fails to flicker or stays continuously lit, it may indicate a problem with the network connection. Verify the network connection. The port must be connected to a 10/100baseT Ethernet network to function properly. ■ The SCSI and bus indicators show SCSI activity (when lit) on the bus indicated (bus 0, 1, 2, or 3). This should only occur briefly during powerup or configuration, and relatively often when the bridge is transferring data. If the SCSI indicator stays continually lit without corresponding target device activity, it may indicate a problem with the SCSI bus configuration. Verify the SCSI bus configuration. Chapter 8 Chapter 8 LED Indicators 185
![](/manual_guide/products/hewlettpackard-surestore-tape-library-model-10180-hp-surestore-bridge-fc-21-lv-fc-41-hv-installation-operations-guide-6d7bf0e/183.png)