HP Surestore Tape Library Model 20/700 HP Surestore Bridge FC 2/1 LV and FC 4/ - Page 56

Power Distribution Unit Installation (PDU) PDU Installation in the 20/700 Tape Library Note The power distribution units (PDUs) may be different for the FC 2/1 LV and 4/1 HV. The PDU ordered with the FC 4/1 HV may have only seven outlets, the PDU for the 2/1 LV has ten outlets. Either PDU can accommodate both the FC 2/1 LV and the FC 4/ 1 HV bridges. Note The power distribution unit (PDU) for the 20/700 must have the outlets facing up when using either the FC 2/1 LV or the FC 4/1 HV. (See Figure 20 on page 59.) Install the bridge 2 EIA units above the PDU in order to allow enough room for the power cables to be inserted into the PDU outlets. By not having the outlets facing up, the PDU will prevent the back door from closing. 1. The power distribution unit (PDU) should be mounted at the bottom back of the rack. The PDU mounting brackets should be positioned so that they are on the inside of the rack column. The outlets on the PDU must face the top of the accessory rack. The power inlet should be positioned on the right-hand side as you look at the back of the library. 2. Attach the PDU to the holes in the left and right rails with the Torx screws and hex nuts (see Figure 20 on page 59). 58 Power Distribution Unit Installation (PDU) Chapter 3