HP Surestore Tape Library Model 20/700 HP Surestore Bridge FC 2/1 LV and FC 4/ - Page 54
Installing the Fibre Bridge in the Rack, on the right and left rails.
View all HP Surestore Tape Library Model 20/700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Installing the Fibre Bridge in the Rack Note The bridge is mounted into the back of the rack, front access to the bridge is not required. 1. Facing the back of the rack, install a total of four clip nuts, two on the left rail and two on the right rail, above any existing product. 2. Install the clip nuts so that the top nut aligns with the top hole of the L-bracket and the bottom clip nut aligns with the bottom hole (see Figure 19 on page 57). To ensure level mounting, verify that the clip nuts are in the same position on the right and left rails. 3. Holding the bridge in position, align the holes in the mounting brackets with the holes in the clip nuts, and install the indicated screws into the clip nuts and hand tighten. 4. After the bridge is in place, tighten all screws. 56 Installing the HP Surestore Bridge Chapter 3