IBM 88614RX Maintenance Manual - Page 140
Power LED errors, Make sure that the NOS CD you have is supported by the ServerGuide
UPC - 000435172662
View all IBM 88614RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Note: See Chapter 7, "Parts listing, Types 8861, 8862," on page 139 to determine which components are replaceable by the customer and which components must be replaced by an IBM field service technician. ServerGuide problems Symptom FRU/action Setup and Installation CD will not start. v Make sure that the server supports the ServerGuide program and has a startable (bootable) CD-ROM (or DVD-ROM) drive. v If the startup (boot) sequence settings have been altered, make sure that the CD-ROM drive is first in the startup sequence. v If more than one CD-ROM drive is installed, make sure that only one drive is set as the primary drive. Start the CD from the primary drive. SCSI RAID program cannot view all installed drives the operating system cannot be installed. v Make sure that there are no duplicate SCSI IDs or IRQ assignments. v Make sure that the hard disk drive is connected properly. The operating-system Installation program continuously loops. v Make more space available on the hard disk. ServerGuide will not start the operating-system CD. v Make sure that the NOS CD you have is supported by the ServerGuide program. See the CD label for a list of supported NOS versions. The operating system cannot be v Make sure that the operating system is supported on the server. If the installed; the option is not operating system is supported, either there is no logical drive defined (SCSI available. RAID systems), or the ServerGuide System Partition is not present. Run the ServerGuide program, and make sure that setup is complete. Power LED errors Use the power-supply LED information in the following table to solve power-supply problems. Notes: 1. The minimum configuration required for the power supply DC good LED to be lit is: v Power supply v Power backplane v Power cord v Memory cassette v Microprocessor tray assembly 2. The minimum configuration required for the system to come on is: v Power supply v Power backplane v Power cord v Memory cassette v Microprocessor tray assembly v I/O board v Operator information panel and cables 130 IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide