Icom IC-718 Instruction Manual - Page 19

4 FREQUENCY SETTING s Frequency setting D Using the tuning dial q Push [∫ UP] or [√ DN] one or more times to select the desired ham band. • For general coverage receiver use The IC-718 has a general coverage receiver band. q Push [∫ UP] or [√ DN] one or more times to select the general coverage receiver band. w Select the desired operating mode with the mode switch. (p. 20). e Rotate the tuning dial to set the desired frequency Note: Even if you select the ham band, you can set the transceiver to the general coverage frequency. When the displayed frequency exits the transmit frequency range (ham band), a band edge beep may be emitted (depends on initial set mode programming). D Direct frequency entry with keypad The transceiver has a keypad for direct frequency entry as described below. q Push [F-INP/ENT], then push the numeral keys on the keypad to enter the MHz digits for the desired frequency. • If a key is mistakenly pushed, push [SET] (or any key except keypad) and start again from the beginning. • When entering the same MHz digits as the displayed [EXAMPLE] •Start F-INP ENT frequency, this step can be skipped. w Push [•] on the keypad. e Push the numeral keys to enter the frequency dig- its below 1 MHz. • If a key is mistakenly pushed, push [SET] (or any key except keypad) and start again from the beginning. r Push [F-INP/ENT] to set the input frequency. • When pushing [F-INP/ENT] after entering the MHz digits, zeros are automatically entered for the kHz digits. •To set to 21.025 MHz 2 1 A=B V/M NR 0 ANF 2 A=B 5 M=CL F-INP ENT •To set to 706 KHz (0.706 MHz) 0 ANF NR 7 0 6 SPL ANF ˛ M V F-INP ENT •To set to 7 MHz 7 SPL F-INP ENT •To change 14.195 to 14.850 MHz NR 8 5 SCN M =CL F-INP ENT 17