Icom IC-718 Instruction Manual - Page 38
Memory channel programming - agc
View all Icom IC-718 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
6 MEMORY OPERATION s Memory channel programming Memory channel programming can be performed either in VFO mode or in memory mode. D Programming in VFO mode q Set the desired frequency and operating mode in VFO mode. w Push [CH], then push [UP Y] or [Z DN] several times to select the desired memory channel. • "MEMO" blinks. • "BLANK" appears if the selected memory channel is a blank channel. e Push [MW] for 1 sec. to program the displayed frequency and operating mode into the memory channel. r Push [CH] to exit memory channel select mode. [EXAMPLE]: Programming 7.086 MHz/LSB into memory channel 10. or keypad MODE CH √ DN or UP ∫ 4 MW Push for 1 sec. Beep Beep Beep CH D Programming in memory mode q Select the desired memory channel with [UP Y] or [Z DN] in memory mode. • "BLANK" appears if the selected memory channel is a blank channel (and does not have contents). w Set the desired frequency and operating mode in memory mode. • To program a blank channel, use direct frequency entry with the keypad in advance. e Push [MW] for 1 sec. to program the displayed frequency and operating mode into the memory channel. • Preamp setting, attenuator on/off,and AGC setting can also be programmed into a memory channel. [EXAMPLE]: Programming 21.280 MHz/CW into memory channel 18. 1 V/M CH √ DN or UP ∫ CH then F-INP ENT [2], [1], [.], [2], [8] F-INP ENT 4 MW Push for 1 sec. Beep Beep Beep 36