Intermec CK71 70 Series Mobile Computer User Manual - Page 109
Con WPA or WPA2 Personal PSK Security with Funk, Con x Security with Funk Security
![]() |
View all Intermec CK71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Chapter 6 - Configure the Computer Configure WPA or WPA2 Personal (PSK) Security with Funk Use the following procedure to configure WPA-PSK or WPA2-PSK with Funk security. 1 Make sure the communications and radio parameters on your computer are configured. 2 Make sure Funk is selected as your security choice. 3 Start Intermec Settings. 4 Select Communications > 802.11 Radio > Funk Security. 5 Select the profile you want to configure. 6 For Association, select WPA or WPA2. 7 For 8021x, select None. 8 For Pre-Shared Key, enter the pre-shared key or passphrase. The pre-shared key must be a value of 32 hex pairs preceded by 0x for a total of 66 characters. The value must match the key value on the access point. The passphrase must be from 8 to 63 characters. After you enter a passphrase, the 70 Series internally converts it to a pre-shared key. This value must match the passphrase on the authenticator. 9 Save your settings. Configure 802.1x Security with Funk Security Use the following procedure to configure 802.1x-WEP security with Funk security. Intermec recommends that you use WPA2-802.1x instead of 802.1x-WEP if possible. 1 Make sure the communications and radio parameters on your computer are configured. 2 Make sure Funk is selected as your security choice. 3 Start Intermec Settings. 4 Select Communications > 802.11 Radio > Funk Security. 5 Select the profile you want to configure. 6 For Association, select Open. 7 For Encryption, select WEP. 70 Series Mobile Computer User Manual 95
![](/manual_guide/products/intermec-ck70-70-series-mobile-user-manual-c5e5fdd/109.png)