Intermec CK71 70 Series Mobile Computer User Manual - Page 111
Con Static WEP Security with Funk Security, Communications >, 11 Radio > Funk Security
View all Intermec CK71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Chapter 6 - Configure the Computer Configure Static WEP Security with Funk Security Use the following procedure to configure static WEP security with Funk. Intermec recommends that you use WPA2-PSK instead of WEP if possible. 1 Make sure the communications and radio parameters on your computer are configured. 2 Make sure Funk is selected as your security choice. 3 Start Intermec Settings. 4 Select Communications > 802.11 Radio > Funk Security. 5 Select the profile you want to configure. 6 For Association, select Open. 7 For Encryption, select WEP. 8 For 8021x select None. 9 Define a value for the keys you want to use. You can define up to four keys (Key 1 through Key 4). Enter an ASCII key or a hex key that is either 5 bytes or 13 bytes long depending on the capability of the radio. Set a 5- byte value for 64-bit WEP or a 13-byte value for 128-bit WEP. Hex keys must be preceded by 0x and contain 5 or 13 hex pairs. 10 For Transmit key, select the key you want to use for transmitting data. 11 Save your settings. 70 Series Mobile Computer User Manual 97