Intermec CK71 70 Series Mobile Computer User Manual - Page 114
Enable WPA or WPA2 Personal PSK Security with Microsoft, Con x Security with Microsoft
View all Intermec CK71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Chapter 6 - Configure the Computer Enable WPA or WPA2 Personal (PSK) Security with Microsoft Use the following procedure to enable WPA-PSK with Microsoft Security. 1 Make sure the communications and radio parameters on your computer are configured. 2 Start Intermec Settings. 3 Select Communications > 802.11 Radio > Microsoft Security. 4 For Infrastructure Mode, select Infrastructure. 5 For Network Authentication, select WPA-PSK. Data Encryption automatically defaults to TKIP for WPA and AES for WPA2. 6 For Pre-Shared Key, enter the pre-shared key or the passphrase. The pre-shared key must be a value of 32 hex pairs preceded by 0x for a total of 66 characters. The value must match the key value on the authenticator. The passphrase must be from 8 to 63 characters. After you enter a passphrase, the computer internally converts it to a pre-shared key. 7 Save your settings. Configure 802.1x Security with Microsoft Use the following procedure to configure 802.1x security with Microsoft security. Intermec recommends that you use WPA2-802.1x instead of 802.1x-WEP if possible. 1 Make sure the communications and radio parameters on your computer are configured. 2 Start Intermec Settings. 3 Select Communications > 802.11 Radio > Microsoft Security. 4 For Infrastructure Mode, select Infrastructure. 5 For Network Authentication, select Open. 6 For Data Encryption, select WEP. 7 For 802.1X Authentication, select TLS or PEAP. 100 70 Series Mobile Computer User Manual