Home » Kodak Manuals » Multifunction Devices » Kodak 5300 » Manual Viewer

Kodak 5300 User Guide - Page 99

Environment, Regulatory Compliance, FCC Compliance and Advisory

UPC - 041778804056

Add to My Manuals
Save this manual to your list of manuals

Page 99 highlights

Appendix CAUTION Do not use your EasyShare AiO near water, or spill liquid on it. WARNING Do not place your EasyShare AiO on an unstable cart, stand, bracket, or table. Injury to persons and damage to the equipment may occur. Environment CAUTION Excessive dust levels may damage internal parts. CAUTION Unplug the equipment from the wall outlet before cleaning. CAUTION Dropping your EasyShare AiO may damage the housing and result in extensive damage that will require repair by a qualified technician to restore normal operation. WARNING Do not expose this product to liquid, moisture, or extreme temperatures. KODAK AC adapters are intended for indoor use only. The use of controls, adjustments, or procedures other than those specified herein may result in exposure to shock and/or electrical or mechanical hazards. For more information, go to www.Kodak.com/go/MSDS. Regulatory Compliance FCC Compliance and Advisory This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures: 1) reorient or relocate the receiving antenna; 2) increase the separation between the equipment and the receiver; 3) connect the equipment to an outlet on a circuit different from that to which the receiver is connected; 4) consult the dealer or an experienced radio/TV technician for additional suggestions. User's Guide 95

Section	Page
Product Overview	5
Main Components	5
Control Panel Layout	6
Status Lights	7
LCD Display Screen	12
Default Display Settings	13
Photos	13
Memory Card Slots and USB Port	13
Supported Memory Cards	14
AiO Home Center (Windows)	14
AiO Home Center (Macintosh)	15
Getting Started	17
Connect Power	17
Install the Printhead	17
Install Ink Cartridges	19
Install the Duplexer	20
Startup	21
Menus	22
Menu Button	22
Photo Button	23
	23
Copy Button	24
	24
Scan Button	25
Help Button	25
Demo Sheet	25
Transfer Photos	26
Configuring Settings	26
Use Print Order if Found	26
Scene Balance	27
Add Date to Prints	27
Button Sounds	27
Minutes to Standby	28
Date and Time	28
	28
Reset All Settings	29
Handling and Loading Paper	31
The Scanner Glass	31
Load Main Tray	32
Load Photo Tray	34
Load Envelopes	35
Load Labels	36
Print	37
Print Photos from a Camera	38
Print Photos from the Control Panel	38
Index Print	39
Print Photos from a Proofsheet	40
Tagged Photos (DPOF)	40
Bluetooth Printing	41
Range	41
User-friendly Name	41
Printing	41
Panoramic photos	42
Layouts	42
Set Print Layout	44
3.5x5 Inch Paper	45
4x6 Inch Paper	46
5x7 Inch Paper	47
8x10 Inch Paper	48
US Letter	49
A4 Paper	51
A5 Paper	52
A6 Paper	53
B5 Paper	54
Setting Print Options	54
Set Number of Prints	55
Set Color	55
Set Print Quality	55
Save Settings	55
Previewing Photos	56
Preview Mode	56
Zoom Photos	57
Multiview	58
Copy	61
Copy with Control Panel	61
Same Size Copy	62
Fit to Page Copy	63
Scale Percent Copy	64
Photo Layout Copy	65
Setting Copy Options	66
Set Number of Copies	66
Set Color	66
Set Quality	66
Change Brightness	67
Set Preview	67
Save Copy Settings	67
Previewing Copies	67
Previewing Copies	67
Zoom and Crop	68
Scan	69
Scan with Control Panel	69
Save Scan Settings	69
Scanning Photos	69
Scan to File	69
Scan to Application	70
Scan to Memory Card	70
Scanning Documents	70
Scan to File	71
Scan to Application	71
	71
Scan to Memory Card	72
Maintenance	73
General Care	73
Clean the Scanner Glass	74
Clean the Scanner Lid	74
Format Memory Card	74
Print Diagnostic Sheet	74
Firmware Upgrade	75
Ink Cartridges	75
Check Ink Levels	75
Replace Ink Cartridges	75
Printhead	77
Calibration	77
Clean Printhead	78
Replace Printhead	78
Support	81
Contact Kodak	81
Limited Warranty	81
Limited Warranty Coverage	81
Limitations	82
Your Rights	82
Outside the United States and Canada	82
Telephone Customer Support	83
Customer Support Phone Numbers	84
Troubleshooting	84
AiO Fails to Power On	84
Bluetooth Device not Recognized	85
Probable Cause 1	85
Corrective Action	85
Probable Cause 2	85
Corrective Action	85
Device not Recognized	85
Ink Cartridge	85
Color/Black Cartridge Not Recognized	85
Ink Cartridge out of Ink	85
Multiple Paper Feed	85
No Communication with Computer	86
No Paper Feed	86
Paper Jam	87
Printer not Responding	87
Transfer Pictures Failure	88
Wrong Paper Size	88
Print Troubleshooting	88
Envelope Printing Incorrect	88
Multiple-page Document in Reverse Order	88
Photo Print Smudged	89
PictBridge Camera not Detected	89
Picture Will Not Print	89
Pictures Cropped	89
Poor Print Quality	89
Print Skewed or Slanted	89
Probable Cause 1	89
Probable Cause 2	90
Print Spotted	90
Print Too Dark	90
Print Too Light	90
Printing Stops	90
Slow Printing	91
White Edges on Borderless Prints	91
Probable Cause	91
Corrective Action	91
Copy Troubleshooting	91
Copies Faded or Dull Colors	91
Probable Cause 1	91
Probable Cause 2	91
Copies too Light or Dark	92
Copy Cut Off	92
Scan Troubleshooting	92
Scan Fails	92
Probable Cause 1	92
Probable Cause 2	92
Probable Cause 3	92
Probable Cause 4	92
Scanned Image Blank	93
Proofsheet Scan Unsuccessful	93
Probable Cause 1	93
Probable Cause 2	93
Probable Cause 3	93
Appendix	95
All-in-One Specifications	95
Computer Requirements	95
Paper Types	96
	97
Safety	98
Parts	98
Power	98
Location	98
Environment	99
Regulatory Compliance	99
FCC Compliance and Advisory	99
FCC and Industry Canada	100
Canadian DOC statement	100
Waste Electrical and Electronic Equipment labeling	100
Notice to Users in the European Economic Area	100
Glossary	103

Match case Limit results 1 per page

Appendix

CAUTION

Do not use your EasyShare AiO near water, or spill liquid on it.

WARNING

Do not place your EasyShare AiO on an unstable cart, stand, bracket, or table. Injury to

persons and damage to the equipment may occur.

Environment

CAUTION

Excessive dust levels may damage internal parts.

CAUTION

Unplug the equipment from the wall outlet before cleaning.

CAUTION

Dropping your EasyShare AiO may damage the housing and result in extensive damage that

will require repair by a qualified technician to restore normal operation.

WARNING

Do not expose this product to liquid, moisture, or extreme temperatures. KODAK AC

adapters are intended for indoor use only. The use of controls, adjustments, or procedures

other than those specified herein may result in exposure to shock and/or electrical or

mechanical hazards.

For more information, go to

www.Kodak.com/go/MSDS

Regulatory Compliance

FCC Compliance and Advisory

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in

accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, you are encouraged to try to correct the interference by

one or more of the following measures: 1) reorient or relocate the receiving antenna; 2) increase the

separation between the equipment and the receiver; 3) connect the equipment to an outlet on a circuit

different from that to which the receiver is connected; 4) consult the dealer or an experienced radio/TV

technician for additional suggestions.

User’s Guide