Konica Minolta bizhub 160 Service Manual - Page 169
If the Stop key is pressed, instead of the Yes key, the main screen is displayed, and the setting
View all Konica Minolta bizhub 160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
bizhub 160/160f bizhub 161/161f 13. Service Mode (bizhub 160f/bizhub 161f) Field Service Ver. 1.0 Apr. 2005 C. PRN SUB REGIST Functions • To vary and adjust the print start position in the sub-scanning direction. Use • After the PRN MAIN REGIST adjustment has been performed • If the image on the copy deviates in the sub scan direction • When the PH unit has been replaced Adjustment Specification •Adjust the width of C in the printed test pattern so that the following specification is met. Specifications 20 ± 2.5 mm Adjustment Instruction Adjustment Procedure 4007D051AA Setting Range 87 to 113 (1 increment = 0.46 mm) The default setting is "100" If the width of C in the test pattern is longer than the specified width ..... Increase the setting. If the width of C in the test pattern is shorter than the specified width ..... Decrease the setting. 1. Print the test pattern. 2. Check that the width of C in the test pattern meets the specification. If the width of C is out of specification, adjust it according to the following procedure. 3. Enter the "ADJUST" menu in the Service mode. 4. Change the setting. If the shift cannot be adjusted to within the specification with a single adjustment, perform the adjustment again to change the setting. 5. Press the Yes key to apply the setting. NOTE • If the Stop key is pressed, instead of the Yes key, the main screen is displayed and the setting returns to that before it was changed. 6. Print a test pattern again and check it. Adjustment / Setting 136