Konica Minolta bizhub 160 Service Manual - Page 214
Disable V.34 TX for V.34 modem
View all Konica Minolta bizhub 160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 214 highlights
bizhub 160/160f bizhub 161/161f Field Service Ver. 1.0 Apr. 2005 16. Soft Switch Set (bizhub 160f/bizhub 161f only) Switch Bit No. No. Designation # 30 8/7 Pause delay time within digit 6/5/4/3/2/1 Signal tone sensitivity after dial for busy tone # 31 - Reserved # 32 - Reserved # 33 7 V.17 echo protection tone 6 V.29 echo protection tone 5 Compromise equalize enable (CEQ) in the transmit path (TCEQ) 4 Compromise equalize enable (CEQ) in the receiver path (RCEQ) # 34 - Reserved # 35 8/7 Dial tone table switch time 6/5/4 Dial tone frequency upper range index 3/2/1 Dial tone frequency low range index # 36 8 Re-dial attempts continue fall counter 4/3/2/1 Re-dial attempts fail limitation counter # 37 8 Polling TX type for V.34 modem 7 Auto dial learning for V.34 modem 6/5/4 RX start symbol rate for V.34 modem 3/2/1 TX start symbol rate for V.34 modem # 38 8 Fine tone of 33.6 kbps/ 33.2 kbps receiving speed for V.34 modem 7 Set/ reset V.34 transmit level deviation 6/5 V.34 flag number between ECM frame 4 Phase 2 guard tone power level (V.34) 2 Polling RX start speed 1 V.8/ V.34 capability # 39 8 Disable V.34 TX for V.34 modem 7 Disable V.34 RX for V.34 modem 6/5 Flags number in ECM frame for V.34 modem 4 Manual TX mode for V.34 modem 3 Switch from V.17 to V.34 if DIS bit 6 set after received DIS 2/1 Delay time in primary channel for V.34 transmit after CFR or MCF signal # 40 8/7/6/5 V.17 RX start speed 3/2/1 V.34 RX start speed # 41 8/7/6/5 V.17 TX start speed 3/2/1 V.34 TX start speed # 42 - Reserved # 43 - Reserved # 44 - Reserved # 45 6 Closed network Page No. ☞ 206 ☞ 207 ☞ 207 ☞ 208 ☞ 208 ☞ 209 ☞ 210 ☞ 211 ☞ 212 ☞ 212 ☞ 213 ☞ 214 ☞ 215 ☞ 215 ☞ 215 ☞ 216 Adjustment / Setting 181