Konica Minolta bizhub 160 Service Manual - Page 232
Soft Switch: #21
View all Konica Minolta bizhub 160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
bizhub 160/160f bizhub 161/161f Field Service Ver. 1.0 Apr. 2005 16.8.21 SOFT SWITCH: #21 16. Soft Switch Set (bizhub 160f/bizhub 161f only) Bit Designation No. Function Initial Setting Bit HEX 8 NSS signal before 0: Not to send NSS signal if remote side is same model 1 C DCS 1: Send NSS signal if remote side is same model 7 CNG duration after Duration (sec) 40 60 70 120 1 6 dialing(T1) Bit 7 0 0 1 1 0 Bit 6 0 1 0 1 5 T4 timer 0: 3.0 sec - Normal case 0 1: 4.5 sec 4 Reserved Reserved 0 0 3 DIS signal length 0: Normal length (bit 1 to 64) 0 1: 4 bytes DIS command - bit 1 to 32 only 2 Increase default T1 Description (sec) T1 T1+ 30 T1+ 40 T1+60 0 1 timing during calling Bit 7 0 0 1 1 0 Bit 6 0 1 0 1 • Bit 1 to 2:T1 indicates the calling time after dialing, can adjust the T1 time longer by changing the default value. The default T1 timer depends on each country regulation. • Bit 3 :Some old machines can not accept DIS command over 4 bytes, and every time will become fail. In this case you can set this bit to 1. If this bit is set to 1, JBIG and V8 capability will be disabled automatically. • Bit 6 to 7:A fax to be received is cancelled and the machine becomes unable to receive it if the setting of "No. of RINGS" is made longer than the setting of "CNG duration after dialing." Be sure to make the "No. of RINGS" setting to a value shorter than the "CNG duration after dialing" setting. ☞ Utility Mode/ RX operation/ No. of RINGS • Bit 8 :Sender machine's name will show on the other party's LCD or print on the report if remote side is the same model. Adjustment / Setting 199